Description: Firewall leadthrough's made to hide ugly jagged holes My fire wall had lots of jagged holes cut in odd places. I decided to clean it up a bit and made the aluminum grommets to hide the jagged holes and to ease the placement of the various cable/wires etc through.
Out of chunks of aluminum I turned up large "bolts" a bit over size to the holes. I then cut them through lengthwise, re turned them true and cut a thread on the shaft of the "bolt" I then made nuts to fit. The hole through these could be straight or at an angle depending on the direction of the cables. See the picture of the fire wall and the direction of the cables for the throttle and tach cable.
Bit of over kill but I enjoyed doing it and its probably pretty fire proof.
For the wires going through the fire wall I wrapped them in fiberglass tape then put the two halves together and finally the nut on the inside. You must not forget to put the cables/wires through the nut first.
You can see how I made them in the first picture, I put small pins in them to hold them together true and you can see that this one shown has the hole at an angle, probably was the throttle one.