Description: This Album contains pictures for the "wing rotisserie". This is what Dad wrote on the f-AA list email:
"I used 1/2" (ID) galvanized water pipe to make most of it. I made a bracket to fasten one end to the tractor wheel, then drove the tractor over it winding it around the wheel about 1 1/2 turns. The tractor wheel is too small compared with the diameter you need for the wing. It was easy then to open the loop up a bit and cut and weld it together for the right diameter. A few blows with a 10 pound hammer took out any distortion.
I then welded two parallel pipes across it, one above the other below the center line far enough apart to give clearance above and below the ribs. Four more "spokes" were welded in to give it rigidity, two above and two below the parallel bars.
The rollers were made from hardwood turned up like a pulley in my lathe, the only reason one was bigger in diameter than the other was because I couldn't find a large enough block for the second.
I welded some short pieces of tube to one of the cross bars to fasten onto false lift strut ends that I made to be the same shape and dimension as the lift struts. You will see in the shot "strut attach2" that there is another piece welded onto the other side of the cross bar, this is for the other wing.
To keep it at right angles to the wing, I just used two lengths of pipe from the outer ring, diagonally down to the jury strut attach brackets on the wing with a couple of brackets to screw them to these jury strut brackets. I think you can see this in some of the links Don sent. I fastened these braces to the outer ring with "Downey" clamps which are the sort of clamps they use making scaffolding. This did not stop it running past the pulleys.
The rotisserie is in storage behind the tractor shed (waiting for the next Aeronca!?) so will take a photo tomorrow of it off the wing which will give a better idea of it.
I've done wings before without a rotisserie and really wonder who I ever did it. It really makes life easy when working on the wings and is well worth the effort to make one.
By the way, at the but rib end a bar was bolted to keep the distance apart of the spars correct, and this acted as the other point to swing the wing around. "
There other pictures of the rotisserie in the wing recover photo albums too.