Photo info

Random image

Navigator

  • Inside of the strut bracket & re-inforcing patch
  • Layer of glue brushed into the leading edge.
  • Top fabric 'locked' in place - Waiting for the gluing and then first shrink to 250F.
  • Close up of the aileron bay shroud.
  • Aileron bellcrank hinge.
  • Jury strut re-inforcing patch
  • Half glued leading edge.
  • All fabric shrunk
  • Ribstitch reinforcing tapes applied

Aileron bellcrank hinge.

                                                                                                      More
Aileron bellcrank hinge. IMG_8465-1280x853.JPG The Aileron bell crank protrudes below the fabric so I've cut a hole & re-inforced it with an acetate ring. Previously this had an inspection hole and the bell crank rubbed on the inspection cover. I've seen one other Auster done this way & didn't think it looked too bad.

Comments

No comments yet.

  •