What to do with holes in Ribs that have been stripped and the PK screw no longer holds very well.

                    More
What to do with holes in Ribs that have been stripped and the PK screw no longer holds very well. IMG_8217-1280x853.JPG All ribs had at least two holes and some had three holes all in close proximity. Rather than drill yet another ole in each rib I chose the hole that was the smallest. In some cases this still didn't provide enough material to hold the PK screw. So I made some small "nuts" to go behind the rib. These nust were made out of a 1/2" strip of .032" 6061-T6 with a #43 hole drilled. Very fiddly & time consuming but I'm happy with the result.

Comments

No comments yet.

  •