Description: When I did my biannual this year I discovered the instructor wouldn't teach my daughters to fly in Dad's Aeronca Chief or my Auster. They don't have full dual controls - Specifically dual brakes. So I persuaded Dad the Stinson needed dual brakes. He'd originally looked at using some of the brake bit's he acquired along the way from a 108-3 but couldn't make them work. Well the Univair kit arrived last week and here they are fitted. Here is what Dad had to say on the Yahoogroups Stinson list:
"Guys, there was thread recently about fitting right brakes to a -1 or -2. I made a few observations as I was fitting the (very expensive) right brake kit from Univair.
First it would seem that the kit was straight from a -3, but as I didn't have any thing to compare with I wouldn't be sure. The right pedal right side is in the same position as the -1/2. The right brake left side is about 1/4" to the left compared with the -1/2.
Similarly the left brake pedal on the left is in the same place but the left brake on the right side is about 1/4" to the right. If you were to use the bar assembly that holds the master cylinders, from a -3 you would have to cut it from the fuselage making sure you
cut it as close to the weld on the fuselage as possible, as this then could be used to bolt on to the old brackets on the -1/2 fuselage.
In the kit they supply a new tube assembly for the master cylinders so that you then have to cut off the old one leaving enough of the tabs on the fuselage to drill and bolt the new one on.
I made measurements of the old set up before cutting it off so that I could get it back on at the right height. If you cut it off as in the instructions it would not be at the correct height.
You also have to cut the floor board slots wider to accommodate the different pedal positions and also because the master cylinders are now more to the left than before.
I found it very difficult to take out and refit the floor boards so I cut each of them down the middle and made four pieces which made it very easy to take in and out. I've attached some photos of the work and finished set up. Shows how I joined up the floor boards after cutting them.
The floor boards may not have been exactly as the originals as I had made new ones in 1978 when I first rebuilt the aircraft."
(Note: these are all my photo's. The attached photo's Dad refers to are on the Yahoogroup).