Photo info

Random image

Navigator

  • Measuring the torque on the end of the outer drag wire.
  • Measuring the torque on the end of the outer drag wire.

Measuring the torque on the end of the outer drag wire.

    More
Measuring the torque on the end of the outer drag wire. IMG_8203-1536x1024.JPG I measured the rough torque on the drag / anti-drag wire ends using a 5BA open end spanner & spring balance. The goal was not to achieve an accurate torque but to ensure I didn't exceed the torque values for the 2BA thread on the wires. I used 20 - 25 in/lbs torque as a guide from the AN3 torque values in AC43.13. With a 2.56" reach on the 5BA open ender this equated to a pull of between 7.7 & 9.7 lbs on the srping balance.

Comments

No comments yet.

  •