More
Measuring the torque on the end of the outer drag wire.
IMG_8203-1536x1024.JPG I measured the rough torque on the drag / anti-drag wire ends using a 5BA open end spanner & spring balance. The goal was not to achieve an accurate torque but to ensure I didn't exceed the torque values for the 2BA thread on the wires. I used 20 - 25 in/lbs torque as a guide from the AN3 torque values in AC43.13. With a 2.56" reach on the 5BA open ender this equated to a pull of between 7.7 & 9.7 lbs on the srping balance.